Sensor Plates
Guide to understanding 3D Motion Plate data output in Swing Catalyst
To help break the golf swing into parts we define four phases and four key points outlined below. The key points (in bold) are shown in Swing Catalyst as…
Balance Plate Warranty and ESA
The Balance Plate consists of an array of highly accurate pressure sensors. Due to the nature of the pressure sensors they need re-calibration after a…
Dual Force Plate installation guide
Dual Force Plate installation guide
How to install a Balance Plate 3
This support article will describe how to setup a new Balance Plate 3 for use with Swing Catalyst.
How to install Balance Plate 3S
This support article will describe how to setup a new Balance Plate 3s.
How to install Dual Pressure Plate
Use the QR code on the back of the welcome card you received with the plates or click here to register your plates. After registering, you get an email…
How to remove noise from your pressure sensor (zero set calibration)
How to remove noise from your pressure sensor (zero set calibration)
How to use BodiTrak sensors with Swing Catalyst
This support article will describe how to setup and configure BodiTrak 2 Vector sensor plates with Swing Catalyst. Technically this article can be used for…
How to use Dual Force Plates with Swing Catalyst
How to use Dual Force Plates with Swing Catalyst
Installing and Setting Up the 3D Motion Plate
The software automatically installs the drivers for the force plate and pressure plate's (except the calibration file). Installing it manually shouldn't be…
Installing and Setting Up the Dual Motion Plate
Installing and Setting Up the Dual Motion Plate